Brillion Field Commander HFC16, Operator'S Manual, Assembly Instructions, Page: 41 / 64

2K314
15. Shanks.
---Assemble the sweeps or points to the shanks before mounting the shanks.
Note: The field cultivator is designed for using 7” wide sweeps, if wider sweeps are
used, be sure to check clearances around all tires in both the operating and
transport positions.
For assembly of points using the Quick-Change Point Assembly:
1. Insert one 7/16” capscrew first through the
spring clip, then the bracket and shank,
and fasten loosely with self-locking flange nut.
2. Insert the other 7/16” capscrew through bracket
and through slot in shank and twist on self-locking
flange nut. Now tighten both nuts.
3. Slide point over shank and bracket assembly
positioning it so that the raised spot on the
spring clip is under the hole in its neck. Fit will be
tight. Strike the point with a hammer to slide it
on and keep it in place.
Capscrew,
7/16-14 NC x 1 1/2”
Spring Clip
Bracket
Utra-Wing
Point
Self-Locking
Flange Nut
ASSEMBLED POINT
NOTE : The spring clip helps to hold the point
on the bracket. However, it is not necessary for
the hole to mate perfectly with the spring clip.
Position sweep so
that raised spot on
spring clip is under hole
in sweep neck.
A. Mount the shanks to the field cultivator according to figures 21, 22, 23, and 24.
Figure 20A
194rev3-4-05 Page 31