Brillion Field Commander HFC16, Operator'S Manual, Assembly Instructions, Page: 11 / 64

2K314
d. Extend the cylinders and hold the control lever in the extend position until there is no
motion in any of the cylinders, check the pin center distances, if they are not all approxi
mately 28 1/4”, retract the cylinders, disconnect the pins from the wheel arms, and bleed
the air from the hydraulic circuit by extending and retracting the cylinders at least
3 times. At the end of each extend stroke, hold the hydraulic control lever at least 30
seconds, or until there is no movement in any of the cylinder rods.
e. Reconnect the cylinders to the wheel arms, and raise the machine by extending the
cylinders.
If your machine is less than 20 feet wide, proceed to step 3.
2. Measure to see that the wings are the same height from the ground as the center section.
a. If the heights are equal, proceed to step 4.
b. If the heights of either or both wings are different than the center section, adjust the
wing cylinder anchor brace rods until the wing is the same height as the center.
1. The wing cylinder anchor braces can be adjusted independently of each
other and independently from the center section.
2. Turn the adjust tube clockwise to raise the wing; counter-clockwise to lower
the wing.
3. 1 turn of the adjust tube will equal about 5/16 inch of height difference.
Note: You will have to lower the machine onto the shanks to be able to turn the adjust tubes.
Wing Cylinder Anchor Brace Rod
Adjust Tube
& Handle
Cylinder
Anchor
Depth Adjust
Depth Indicator
Cylinder
Lock
194rev3-4-05 Page 8