Brillion Field Commander HFC16, Operator'S Manual, Assembly Instructions, Page: 31 / 64

2K314
10. Wing wheel cylinders.
A. Using the pins that are packaged with the cylinders, connect the butt end of the
cylinder with the 3 3/ 4” bore (part number 2K-087 is stamped on the box and on
the cylinder barrel) to the cylinder anchor. Connect the rod end to the lug on the
wheel arm. Mount these cylinders with the ports up.
IMPORTANT The cylinder pins should be secured with cotter pins. If hairpin clips a
packaged with your cylinders, do not use them as they may have a tendency to
become loose. The ends of the cotter pins should simply be bent over, do not fold
the ends of the cotter pins into the groove on the cylinder pins.
11. Wing gage wheels for 16 foot through 19 foot wide machines.
A. Mount (2) 6.70-15 or 7.60-15, 4 ply tires on the 15 x 4.5 KB 4 bolt rims and attach
to the hubs of the wheel arm assemblies.
B. Mount the wheel arm to the pivot tube welded to the bottom of the wing. Extend
a 1 1/4 O.D. x 2 15/16” long bushing through the lugs on the wheel arm and
through the pivot tube of the frame. Secure the wheel arm to the frame by
extending a 3/4 x 5” long capscrew with a flat washer through the bushing and
fasten with a flat washer and a 3/4” locknut. The wheel arm must be able to pivot
on the frame.
C. Connect the single hole of the gage wheel adjust bar to the outside of the gage
wheel arm with a 3/4 x 3 1/2” long capscrew and a locknut. The adjust bar must
be able to pivot on the wheel arm. Extend the gage wheel adjust bar between
the two lugs on the top of the wing and lock in place with a 3/4 x 2 3/4” long clevis
pin and a hairpin clip.
12. Wing lift cylinders.
A. Center the wing lift cylinder anchor on top of the rear frame tube of the center
frame.
Note: The wing lift cylinder anchor is not symmetric, and must be mounted with
the cylinder lug offset to the rear as shown in figure 16.
B. Secure the cylinder anchor to the rear frame tubes with (8) 5/8” diameter x 4” wide
x 4 1/2” deep U-bolts, lockwashers and nuts.
C. Using the clevis pin supplied with the cylinder, attach the butt ends of the two 30”
stroke cylinders to the cylinder lug. Mount the cylinders with the ports facing the
D. Extend the cylinder, and attach the clevis end between the two lugs on the wings.
Use a 1” diameter x 6” long pin, (2) 1” diameter flat washers, and (2) 5/16” diameter
x 2” long roll pins to attach the clevis.
Note: When using the 3” diameter bore cylinder on 16 foot through 23 foot wide
machines, center the cylinder clevis between the two wing lugs by using 1”
diameter flat washers on each side of the cylinder clevis.
194rev3-4-05 Page 24