Brill brillencio 41 E, Manual

Page: 19 / 232

GB
Translation of original user instructions 18
Fault remedy
Danger - risk of injury!
Before all maintenance and care, always pull the mains plug, and wait until the cutting blade comes to a standstill!
Fault Possible cause Solution
Motor does not run No power supply
Check the in-house fuse / extension cable
Unit cable defective
Contact the AL-KO service centre / an authorised
specialist firm
Cutting blade blocked
Clean discharge chute / housing, the cutter blade must
turn freely
Current the cutting height for lower grass or previously
mowed areas
Reduced motor
performance
Too much grass in
the discharge chute
or housing
Clean discharge chute / housing
Correct the cutting height
Cutting blade blunt Contact an AL-KO service centre or authorised specialist
firm and have the cutting blades sharpened or replaced
Grass catcher does not
fill up completely
Lawn is wet Allow the lawn to dry
Grass catcher clogged Clean the grass catcher grid
Too much grass in
the discharge chute
or housing
Clean discharge chute / housing
Correct the cutting height
Cutting blade blunt Contact an AL-KO service centre or authorised specialist
firm and have the cutting blades sharpened or replaced
Unusual noises Screws loose Tighten screws
Consult AL-KO service centre
Irregular running, strong
vibration of the unit
Cutting blades damaged Have cutting blade exchanged
Lawn becomes yellow
Cut uneven
Cutting blade blunt
Cutting height too low
Have the cutting blades exchanged or sharpened
Raise cutting height
Tracks of mower too
deep during mowing
Soil softened by
moisture, lawn too wet
Let the lawn dry, do not mow when the grass is wet
If faults are not listed in this table or you are unable rectify them yourself, please consult our customer service
department.