Brill 40 BC, Manual

Page: 27 / 96

GB
27
A
Use /
Responsibility
Make sure that there are no other
people (especially children) or
animals within or near the working
area.
Powered equipment can cause seri-
ous injuries! You are responsible
for safety in the area where you
are working. Never start the equip-
ment whilst tilted – risk of injury!
Always use the equipment solely
for the purpose described in the
operating instructions.
Never permit the combustion
engine to run in enclosed spaces
where dangerous exhaust gases
can collect.
Only work in daylight or with
adequate artificial lighting.
Ensure that you are standing safely
and on firm ground, even on a
slope. Work across the slope, never
up and down. Do not work on
excessively steep slopes. Be careful
if you change direction on a slope,
turn the machine round or draw
it towards you. Be careful if
you are going backwards, risk
of stumbling!
Only push the equipment at walk-
ing pace.
Turn the motor off if the equipment
has to be tilted when transport-
ing it over surfaces other than
grass and if you are transporting
the equipment backwards and
forwards to the work area. Never
use the machine with damaged
protective devices or without pro-
tective devices.
Never change the basic settings of
the machine or rev the engine too
hard.
Disconnect all the cutting tools and
drives before you start the motor.
When starting or operating the
starter switch take care as stipulat-
ed by the manufacturer’s instruc-
tions. Ensure that your feet are far
enough away from the cutting tool.
When starting or switching on the
motor, the machine should not be
tilted unless the machine has to be
raised during the process. In this
case only tilt it as far as absolutely
necessary and only raise the side
away from you.
Do not start the motor when
you are standing in front of the
discharge duct.
Keep your fingers and feet away
from the cutting tool!
Never lift or carry a machine with
the motor running.
Each time you have to work on
the machine or leave it or top it up,
always switch off the motor.
If you strike an obstacle when
working, please disable the
machine. Remove the spark plug.
Remove the obstacle, check the
equipment for any damage and
have it repaired if necessary.
If the equipment begins to vibrate
strongly, unplug from the mains
and ascertain the cause.
A
Taking
a Break
Never leave the equipment unat-
tended. If you stop work, switch
the machine off and remove the
spark plug.
If you stop work to go to a differ-
ent work area, it is essential to turn
the equipment off and remove the
spark plug.
A
Beware of Environmental
Influences
Comply with local quiet periods
in your community!
The manufacturer warrants its prod-
ucts for exclusively non-commercial
use for a period of 24 months from
the date of original purchase.
This warranty does not affect statu-
tory warranty claims. The warranty
covers all substantial faults of the
product, which are caused by
defects in material and workman-
ship. If a product exhibits such
a defect we will, at our option,
repair or replace it without cost for
parts and labour provided the fol-
lowing requirements are fulfilled:
.
The product must have been sold
to the customer in a legally cor-
rect way.
.
The original receipt with the
customer’s address, date of pur-
chase, model and product desig-
nation is presented as proof of
purchase. The product must have
been purchased within the EC.
.
The product was handled pro-
perly and according to the
recommendations in the operat-
ing instructions. It is essential that
the product has been maintained
and cleaned according to the
information in the operating
instructions. No attempt to disas-
semble or repair the product has
been made by either the buyer or
an unauthorised third party.
.
It must be ensured that only
original replacement parts and
original accessories approved
by the manufacturer are used.
There may be an increased risk
of consequential damage and
accidents if non-original parts
or non-original accessories are
used. This warranty does not
cover consequential damages.
.
The product must be either taken
directly or sent with postage paid
to an authorised service centre.
The original receipt must be sent
with the product.
.
The warranty does not cover
damage from misuse, abuse, use
Warranty