Briggs & Stratton Vanguard 430000, User Manual

Page: 124 / 159

121
11
2. Remove pulley and spacer. Replace pulley if
damaged or worn.
3. Remove nut and insulator at “B” terminal ( A ,
Figure 20). Remove three screws and brush
cover (
B ).
Figure 20
4. Remove two screws and brush retainer
assembly ( A , Figure 21).
NOTE: Length of brush retainer screws is different.
DO NOT mix.
• Screw #1 - 0.45 in. (11.5 mm) ( B ).
• Screw #2 - 0.35 in. (9.0 mm) ( C ).
Figure 21
5. Remove three screws and regulator ( A ,
Figure 22).
Figure 22
6. Remove stator lead screws from rectifier ( A ,
Figure 23).
7. Carefully straighten stator leads ( B ) and
remove rectifier.
Figure 23
8. Place a reference mark on the drive end and
brush end housing so that they may be
reassembled in original position.
9. Remove two nuts and two thru bolts ( A ,
Figure 24).
10. Remove brush end housing being careful not
to damage stator leads.