Not for
Reproduction
25
Power
Winding
Circuit
Breaker
To Generator
Circuit
Breaker
NOTICE
Generator must be used
ONLY
with transfer
switch Part Number 071060
INSTALLATION
cont.
Figure 15
AC Connections
Generator AC Connection System
A single-phase, two wire with ground AC connection
system is used in the generator. A complete
schematic diagram is in the back of this manual. See
Table of Contents
for page number.
To Transfer Switch
33
230V
11
22
44
11
44
L1
L2
0
WARNING
Electrical Shock - Failure to properly
ground generator could result in electrocution.
Failure to isolate generator from utility power
could result in death or serious injury to utility
workers due to backfeed of electrical energy.
If you must work around a unit while it is
operating, stand on an insulated dry surface
to reduce risk of shock hazard. Despite
the safe design of the generator, operating
this equipment imprudently, neglecting its
maintenance or being careless could result in
death or serious injury.
DO
• Do
have the electrical system meet national
rules and regulations of the respective
country when generator is installed. This
includes the Residual Current Device
(RCD).
DO NOT
• Do not
touch bare wires or bare
receptacles.
• Do not
use generator with electrical cords
which are worn, frayed, bare or otherwise
damaged.
• Do not
handle generator or electrical cords
while standing in water, while barefoot, or
while hands or feet are wet.
In case of an accident caused by electrical
shock, immediately shut down the source of
electrical power and contact the local authorities
or emergency response units. Avoid direct
contact with the victim.
