Briggs & Stratton 130G00, Repair Manual

Page: 77 / 112

Not for
Reproduction
93
36. Install dipstick oil plugs into crankcase cover and tighten
as follows.
Dipstick Oil Plugs
Torque Models
10-30 lb-in (1.1-3.4 N-m) 130G00, 131G00, 13R200
18-27 lb-in (2-3 N-m) 13U100, 13U200
37. If equipped, lubricate O-rings with clean engine oil and
install high oil fill tube into crankcase cover. Install hex
flange screw to fasten flange to crankcase cover and
tighten to 20-40 lb-in (2.3-4.5 N-m).
38. If not equipped with stator, move to step 39. If stator
equipped, proceed as follows:
A. See Figure 94. Orient stator, so that wires are at
the top and facing the crankcase. Route wires
through opening (A) in crankcase.
B. Start two hex flange screws (B) to fasten stator to
crankcase. Alternately tighten screws as follows.
Stator Screws
Torque Models
80-110 lb-in (9-12.4 N-m) 130G00, 131G00,
13R200
71-124 lb-in (8-14 N-m) 13U100, 13U200
C. See Figure 95. Tightly pull stator wires through
opening in crankcase, and then keeping wires tight,
route between ribs at top of crankcase. Push down
on wires, so that they are snugly seated against
casting.
NOTE: Through contact with the governor lever,
link, or springs, loose wires can interfere with
governor operation.
94
95
39. See Figure 96. Install top hex flange screw (A) to fasten
flywheel guard (B) to crankcase. Tighten screw as
follows.
Flywheel Guard Screws
Torque Models
60-110 lb-in (6.8-12.4 N-m) 130G00, 131G00, 13R200
71-124 lb-in (8-14 N-m) 13U100, 13U200
71
7