Briggs & Stratton 130G00, Repair Manual

Page: 83 / 112

Not for
Reproduction
Low Oil Sensor Module (If Equipped)
1. See Figure 109. Route wire from either armature or
rocker stop switch between ribs at top of crankcase.
First pull wire tight and then push down firmly, so that
it is snugly seated against casting. Capture wire in clip
on flywheel guard.
NOTE: Through contact with governor lever, link, or
springs, loose wires can interfere with governor
operation.
2. See Figure 110. Install hex flange screw (A) to fasten
oil sensor module bracket to flywheel guard. Tighten
screw as follows.
Low Oil Sensor Module Screw
Torque Models
30-80 lb-in (3.4-9 N-m) 130G00, 131G00, 13R200
35-71 lb-in (4-8 N-m) 13U100, 13U200
3. Connect one-place wire connector (B) between oil
sensor module and either armature or rocker stop
switch.
4. Connect one-place wire connector (C) between oil
sensor module and oil sensor.
109
110
Blower Housing
1. See Figure 112. If equipped with rocker stop switch (A),
connect wires to spade terminals as follows:
A. See Figure 111. If equipped, connect socket of low
oil sensor module wire to terminal 3.
B. Connect socket of armature/remote magneto stop
terminal wire to terminal 2.
C. Connect socket of red wire ring terminal (stop
switch ground) to terminal 1.
111
112
77
8