10
Installation
6.4 Glass Door Installation
WARNING:
Do not operate appliance with the glass front removed, cracked, or broken. Replacement of the glass should be done by
a licensed or qualified service person. Do not attempt to remove the glass door when the appliance is hot. Be sure there
are no fingerprints left on the glass panels during install or when cleaning as high temperatures can bake these prints on
permanently. Inspect the door gasket to ensure no damage has occurred when installing the glass door.
If Your Glass Breaks
In the event your glass cracks or breaks, replace the original door
assembly with replacement door assembly (part number 824-0000
for the Black door or 824-0001 for the Brushed Nickel). The glass
door and frame assembly must be replaced as a complete unit.
Remove the barrier screen (See
Section 6.3
) and remove door as
per the instructions above. Replace with new door assembly and
reinstall the barrier screen.
NOTE:
the NEW door will emit some odor when the appliance
is lit. The odor will dissipate after the gasket material within the
door has cured. Be sure there are no fingerprints left on the
glass panels as high temperatures can bake these prints on
permanently.
Warning:
Only doors certified with the appliance shall be used.
Do not use substitute glazing materials.
Step 02)
rotate the bottom toward the fireplace. Make sure the
door gasket doesn't roll up onto the top of the firebox.
Step 03)
Pull the door buckles under the firebox out and latch the
bottom of the door.
Figure 6.4.02:
Figure 6.4.03:
Removal is the reverse of instllation.
Step 01)
Hold the door at approximately a 30 degree angle. Lower
the top of the door onto the top hooks.
Figure 6.4.01:
Figure 6.4.04:
