Bricon X-treme, User Manual

Page: 4 / 21

1) Installation
1.1 Foreword.
Thank you for your trust and confidence in BRICON.
This Manual will give a detailed explanation of the functions of your X-treme clock.
We are confident that you Bricon electronic timing system will bring you much enjoyment.
1.2 Instructions.
- Protect the X-treme against humidity and sunlight.
- Set the X-treme not expose to expose to extreme temperatures or temperature fluctuations.
1.3 The X-treme system.
A X-treme pack contains: :
1.4 Assembly of the Bricon electronic timing system.
The antennas must first be programmed before the clocking system is installed (Page 7).
To connect the antennas, we use the supplied cables.
These have on both sides a 9-pin connector, male and female.
Turn the screws by hand.
In the same way connect the X-treme to the antennas.
Connect now the power supply to the connector of the loft antenna.
With a good working system all red lights on all the antenna plugs are on and the display of
the X-treme light.
If not there is some ware a cable break or no voltage present.
Check the wiring and make sure the power supply equipped with 230V AC.
Examine the drawing on the next page carefully before you install the clocking system.
On the figure are male connectors indicated by M and female by F.
The cables can extended if required and are available in various lengths and can be obtained
from your BRICON distributor.
If possible connect the power at the centre of the system
If you connect more then 4 antennas, install the end plug. If there is no fancier data in the
clock, the clock starts in antenna test.. After you press the ’OK’ button, the antenna test
starts automatic (see 2.4 on page 8).
If there are questions or problems , contact your Bricon distributor.
X-treme 4