BRICK 5411074121846, Manual

Page: 19 / 24

22. Keep the table flat and do not scratch or
press the table.
23. Do not put hands anywhere near the blade
whist it is rotating.
24. Do not attempt to free a jammed blade
without first switching off or removing the
plug from the mains power supply.
25. Keep water full in the tank when you
operate the cutter.
26. Do not use any solvents for instead water
in this tool.
27. Disconnect the tool from power source
when not in use or before servicing.
SPECIFIC SAFETY RULES
1. Ensure that the directional arrow on the
blade corresponds with the rotational
direction of the motor.
2. Periodically check to be sure the locking
arbor bolt is tight, and the blade is securely
fastened to the arbor shaft.
3. Check the blade carefully to see if cracked
or damaged before use. If cracked or
damaged, replace it immediately.
4. Only use a RCD-protected power source or
connect to an electrical power point using
an approved RCD circuit breaker. This is
an essential safety precaution.
5. Keep the cord away from the cutting area
and position it so that it will not be caught
on the work piece.
6. Before switching on, check that all
spanners and setting tools have been
removed.
7. Never try to cut freehand. Only cut tile that
is securely held against the fence of the
sliding table or the mitre gauge. Never try
to cut pieces that are too small to be held
securely or that do not allow you to keep
your hands safely away from the blade.
8. Ensure that the work piece that will be cut
off has sufficient room to move sideways.
Failure to do so may result in the off-cut
binding against the blade.
9. Never cut more than one tile at a time.
10. Ensure that the table and surrounding area
are clear with the exception of the tile to be
cut.
11. Before cutting a tile piece, let the blade run
freely for a few seconds. If it makes an
unfamiliar sound or vibrates excessively,
switch it off immediately and disconnect
from the power supply to find the source of
the problem.
12. Allow the motor to come to full speed
before cutting.
13. Allow the motor to come to a full stop
before attempting to remove any jammed
or off cut material from around the blade
area.
14. Never touch the moving parts or the blade
during use.
15. Never remove loose splinters, chips pieces
while the blade is moving.
16. Ensure that cut off tile pieces are not
caught by the blade and send flying.
17. Never walk away from the too until the
motor has come a complete stop. Never
leave the tool unattended when it is
plugged into an electrical outlet. Turn off
the tool, and unplug it from its electrical
outlet before leaving.
18. Never allow the blade to run dry. Cutting
with a dry blade will cause excessive wear
and possible damage to the blade and
motor.
19. When transporting the machine, use only
transportation devices and do never use
guards for handling or transportation.