Breville the Kinetix BBL550EX, Instruction Booklet

Page: 10 / 36

10
OpERATING yOUR BREvILLE pROdUCT
5. Plug the power cord into a 230/240V
power outlet and switch on.
6. Press the POWER button on the far left
of the control panel to turn the blender
on. The POWER button will illuminate
and flash.
NOTE
Do not fill the blender jug above
the MAX line. When the blender
jug is filled at or near the MAX line
place one hand on the blender lid to
avoid displacement of the lid during
operation.
7. Select the required speed (1 to 5) by
pressing the corresponding speed
button. The blender will start to operate
and the selected speed button will
illuminate. The POWER button will
illuminate and cease to flash. The STOP
button will illuminate and flash.
8. Operate the blender only for the
appropriate amount of time required –
do not over blend.
9. When 120 seconds is reached, the
blender will automatically cease to
operate and the selected speed button
and STOP button illumination will go
out. The POWER button will illuminate
and flash.
NOTE
The maximum amount of ice cubes the
blender can blend at any one time is
1 standard ice tray or 250g.
10. For ingredients that require short bursts
of power, select the PULSE function.
The PULSE button will illuminate and
remain illuminated while the button is
depressed. Press the PULSE button in
short bursts until blending is complete.
11. At the end of use, always ensure the
blender is turned off by pressing the
POWER button on the control panel.
Then switch the appliance off at the
power outlet and unplug the cord.
Ensure the motor and blades have
completely stopped before attempting to
move the appliance, or when the blender
is not in use and before disassembling,
cleaning and storing.
NOTE
Do not fill the blender jug above
the MAX line. When the blender
jug is filled at or near the MAX line
place one hand on the blender lid to
avoid displacement of the lid during
operation.
OvERLOAd pROTECTION SySTEm
The motor is protected from burning out
by an automatic, temperature operated,
cut-out switch. If the blender is overloaded
or operated continuously for too long,
the motor may overheat. If this happens,
the safety cut-out switch will prevent the
blender from operating. To operate the
blender again, you must switch off at the
power outlet, unplug and allow to cool for
approximately 30 minutes. Once the motor
has fully cooled, it is ready for use again.