12
Assembly
BEFORE FIRST USE
•
Remove and safely discard any packaging
material or promotional labels attached to
your benchtop unit and filter. Check for
any missing or damaged parts as per the
components list.
NOTE
As an important part of our quality control
process, your unit has been individually tested.
As a result, you may notice a small amount of
condensation or water droplets on the inside
of the water tank. There is no need for concern.
Please remove and discard the protective red
silicone rubber cap from the spout before use.
•
Remove the Activ360™ 4-Stage filter from the
water tank and set aside.
•
Do not wash the filter or insert into the
water tank until ‘Flushing the Breville
AquaStation’ and ‘Preparing the Activ360
Filter’ instructions are completed as found in
this book.
•
Place the unit on a dry, flat level surface.
•
Wash the water tank lid, water tank in warm
soapy water with a soft, non-abrasive cloth.
Rinse and dry thoroughly with a clean, soft,
lint-free cloth before returning to the unit.
•
Assemble the water tank back onto the power
base.
•
Plug the power plug into a 230/240V power
outlet and turn on the power outlet.
IMPORTANT
When moving the unit, always lift from the
base using two hands and set down gently on a
flat and level surface.
FLUSHING THE BREVILLE
AQUASTATION
It is important to flush and rinse the dispensing
system before using the unit for the first time.
Before first use, it is recommended to carry out
the below steps
without
the Activ360™ Water
Filter in place.
1. Fit only the water tank into place on the
base of the unit with the lid removed.
2. Fill the tank with cold tap water to the MAX
level. Never fill past the MAX level.
3. Place a 1L container under the dispensing
spout
4. Press the START/STOP button once to
start dispensing ambient water until the
container is full, then press the START/
STOP button once again to stop dispensing.
Discard the collected water.
5. Repeat steps 3-5 until all the water in the
tank has been dispensed. The unit will stop
dispensing when the water level is too low
or automatically after 60 seconds.
6. Proceed to the next step, ‘Preparing the
Activ360™ Filter’.
PREPARING THE ACTIV360™ FILTER
Flushing the filter is required every time you
insert a new filter cartridge.
3x
MAX
MIN
MAX
MIN
2L
2L
10m
SHAKE FILTER
2L
AMBIENT
AMBIENT
5ºC
10ºC
15ºC
FILTER
RESET
NEW FILTER
2L
90d
3x
MAX
MIN
MAX
MIN
The START/STOP button light will flash
continuously in red to notify after 90 days or
200L of water filtered as an alert that it is time
to replace the filter cartridge.
