4-13
A.
WRAPPING CABLE
12.
With the tarp hand rolled to the cov-
ered position, attach the barrel end of
the cable to the barrel groove on the
spool.
13.
Now wrap the cable around the spool.
Be sure the cable follows the grooves
while doing so. If done correctly, the
cable will have fully wrapped the spool
with barely an inch hanging down.
Attach ball end of the cable to the
ratchet strap hook. See Fig. 12.
Fig. 12
251915-12
Fig. 13
251915-13
ATTACHING CABLES AND RATCHETS
B.
MOUNTING RATCHETS
14.
When the cable is wound on the spool and attached to the ratchet hook, pull down on
the ratchet with one hand, and with the other hand, activate the release on the ratchet
to extend the strap to the mark on the strap. By doing this you will have set the ratchet
to the correct mounting height. If for some reason you cannot mount the ratchet at this
height, lower it slightly to the closest point for mounting. Attach the ratchet to the side
of the box at this level. The ratchet must be securely mounted to the side of the box.
Drill 5/16 holes and use 3/8 x 1 self-threading screws. Before tightening, adjust
brackets to hold cables at an angle as shown. See Fig. 13.
Summary of Contents for Corner Auger
