1-20
K. To assemble guard: (Figs. K1 - K5)
1.
Grease yoke groove and inner profile tube.
2.
Fit bearing ring in groove with recesses facing
profile tube.
3.
Slip on half-guard.
4.
Turn cone until it engaes correctly.
5.
Install locking screw.
L. To assemble cone:
1. Dismantle guard (Figs. J
1
- J
3
). Remove old cone
(e.g. cut open with knife). Take off chain. Place
neck of new cone in hot water
(approx 80
o
C / 180
o
F) and pull onto bearing housing
(Fig. L
1
).
2. Turn guard cone into assembly position (Fig. L
2
).
Further assembly instructions for guard
(Figs. K
1
- K
5
).
3. Reconnect chain if required (Fig. L
3
).
K4
K3
K1
K2
K5
L1
L2
L3
250968K
250968L
Summary of Contents for Corner Auger
