brent Corner Auger, Operator'S Manual

Page: 74 / 80

4-12
To ensure the spring tab fully
engages in the tube cartridge, turn
the spool COUNTERCLOCKWISE
about one inch and push. To fasten
the spool to the cartridge tube, slide
the PVC spacer until holes align, then
bolt with a 5/16 x 1 3/4 bolt and lock
nut. See Fig. 10.
B. FRONT SPOOL (RED)
10. Install the front spool and related com-
ponents in the same manner as the
rear. Then turn CLOCKWISE and
push on. Slide the PVC spacer on
and temporarily bolt on. See Fig. 10.
251915-10
Fig. 10
A. REAR SPOOL (BLACK)
The inside of the spools are pre-greased
for use and color coded for assembly.
9. Slide the rubber ring on the roll tube
about 2 inches. Then insert the black
end of the spring into the black spool
so the spring tab extends through the
small hole in the spool. Slide the
spring with spool over the black end
of the roll tube so that the cartridge
tube extends through the center hole
of the spool.
ATTACHING SPOOLS TO ROLL TUBE
C. ROLL TARP ASSEMBLY
11. Hand roll the tarp into open position.
Place the 1" stationary tube side of
the tarp on top of the left side of the
box, centered from front to back of
box. BE CAREFUL NOT TO LET THE
TARP ROLL OFF OF THE BOX.
Assemble the tarp and stops (26) (with
caps) to the left side boards with
flange screws and flange nuts.
Fig. 11
251915-11
•
04-01-02