30
Chapter 4: Assembling the Bed Face Panel unit.
FIG. 4G - OVERHEAD VIEW
STEP 3
Critical Step
Position the frame
1/2” from
“Mechanism End” and centered
along the left and right sides
.
Attach frame to doors using
screws from hardware package
#7. Use a #2 Phillips bit to insert
screws (see Hardware Package #2). When attaching
screws, attach the 4 corners first, which will help keep
the frame aligned. The position of the frame over the
doors is crucial, so double check alignment as you
insert screws.
Full, Queen and King beds: Make sure the doors are
pushed together so there’s no gap between the doors
and they are even on the ends. It can be helpful to add
a strip of tape between the doors.
For video instructions of this specific chapter, visit:
breda.us/frame
FIG. 4H - OVERHEAD VIEW
Position the middle support
stiffener first,
centered evenly
between the “Mechanism End”
and the “Leg End” and attach
with screws from Hardware
Package #7 (and #8 if available).
Position the other two support stiffeners,
centered
between the middle stiffener and the bed ends and
attach with screws from Hardware Package #7 (and
#8 if available).
STEP 4
Metropolitan Murphy Beds:
To prevent the
screws from poking through the thin areas
on the raised panel door(s), take note of the
underlined text above.
