Page 44
WARNING
Risk of electrical fire!
Install and electrically
terminate Auxiliary
electrical device as
specified by device
manufacturer.
A fuse block that can accommo-
date up to six additional ATO
®
type fuses is provided behind the
dash below the steering column.
This power source is available for
installation of a dealer-installed
power seat, an electric tie-down
or other auxiliary electrical device.
The
installer is responsible for
supplying the correct gauge
wire and fuse
for the particular
device to be attached to the fuse
block (
as specified
by the
manufacturer of the device).
The
maximum load must not
exceed 25 amperes
. Wiring
must be routed and terminated
properly by the installer. Wires
with female fully-insulated termi-
nals can simply be connected to
one of six available terminals on
the fuse block.
Note:
If install-
ing an auxiliary electrical
device that requires more than
a 25 ampere power source, an
alternative power source must
be provided
. Refer to the
Electrical Schematic and Wiring
Diagram contained in this
manual.
Note:
A switch and power-supply
cable are supplied with each
Entervan
®
for use when installing
an auxiliary electrical device (
if
applicable
).
Auxiliary Power Supply
for Dealer-Installed Power Seat or Tie-Down
Troubleshooting
Summary of Contents for EntervanII
Page 45: ...Page 43 Notes Troubleshooting...
