Page 34
Maintenance and
lubrication proce-
dures should be
performed as speci-
fied by authorized
service personnel.
Failure to do so may
result in serious
bodily injury and/or
property damage.
WARNING
Maintenance and Lubrication Schedule
Inboard (floor) ramp hinge
Outboard ramp extension hinge
Ramp fold pick-up bearing
Ramp extension cable
Wheelchair and occupant restraint belts
(
❖
visually inspect before every use)
Inspect removable front seat bases for proper
engagement of latching mechanisms
Ramp fold arm bearing slot
Ramp rotation (Passive Access) top and bottom
pivot points
Passive Access ramp latch
Passive Access ramp latch cable. See
Cable
Adjustment
in
General Inspection
section if
release knob does not seat properly in the knob
retainer bracket (knob contacts bracket prevent-
ing positive latching).
Clean and lubricate with * Light Oil
Clean and lubricate with * Light Oil
Lubricate with * Light Oil
Inspect for proper alignment, securement or
defects such as cuts, fractures, etc. Resecure,
replace or otherwise correct as needed
Inspect for any defects such as cuts, fraying or
any malfunction of belt, buckle or securement
hardware. Replace immediately if defective.
Replace or correct as needed
Lubricate with * Light Grease
Lubricate with * Light Oil
Inspect for proper operation, wear or damage.
Lubricate with * Light Oil
Inspect for proper operation, wear or damage.
Resecure, replace or otherwise correct as
needed.
Perform all procedures listed in previous section also
4 Weeks
or 100
Cycles
❖
continued
1 Year
or
1250
Cycles
Normal vehicle maintenance must be
performed as outlined in the Chrysler-
supplied owner’s manual. This
maintenance is not the responsibility
of The Braun Corporation. Refer to
the Warranty section of this manual
for details regarding The Braun
Corporation Entervan Warranty.
Have an authorized service repairman
perform the following Entervan
maintenance and lubrication proce-
dures at the scheduled intervals
according to the number of cycles or
elapsed time, whichever comes first.
Discontinue
Entervan use immedi-
ately
if maintenance and lubrication
procedures are not or cannot be
properly performed, or if there is any
sign of improper operation, damage,
wear or any abnormal condition.
Contact your dealer or call The Braun
Corporation at 1-800-THE LIFT. One
of our national service representatives
will direct you to an authorized service
repairman who will inspect your
Entervan.
Proper maintenance is necessary to
ensure safe, troublefree operation.
Apply lubricants as outlined in the
chart below.
Note:
Severe conditions
(weather, environment, heavy usage,
etc.) may require more frequent
maintenance. When replacing lubed
components, be sure to lubricate
during installation procedures.
*
Lubricants specified within the
schedule are available from The Braun
Corporation. Part numbers of these
lubricants are provided on page 36.
Maintenance
Summary of Contents for EntervanII
Page 45: ...Page 43 Notes Troubleshooting...
