Page 35
Correct or adjust as needed
Replace if needed
Tighten, lubricate, adjust microswitches,
replace defective parts or otherwise correct as
needed
Inspect for obstructions and clean
Realign, tighten, lubricate, replace defective
parts or otherwise correct as needed.
Cable Adjustment: Loosen cable securement
Allen screws at knob and insert cable further
and resecure. Remove knob and shorten cable
(1/8" intervals)
if needed only
.
Resecure, adjust microswitches, replace
defective parts or otherwise correct as needed.
Note:
See Ramp Motor Assembly exploded
view on page 48.
Replace defective parts or otherwise correct as
needed
Realign, resecure, adjust, lubricate, replace
defective parts or otherwise correct as needed.
Note:
See Kneel Actuator Assembly exploded
view on page 50 also.
Maintenance and Lubrication Schedule
General Inspection
Inspect ramp fold arm for proper alignment with
ramp pick-up bearing
Inspect ramp fold arm bearing slot for excessive
wear or damage
Inspect ramp for proper operation and positive
securement
Lower power slide door track
Passive Access system - inspect:
• Latch for proper operation
(apply * Light Oil)
• Latch mounting hardware for positive
securement (loose or missing mounting
hardware)
• Release cable for positive securement,
alignment, wear, or other damage
• Release knob retainer bracket for positive
securement, deformation, or other damage
• Does release knob seat properly in the knob
retainer bracket? See
Cable Adjustment
if
knob contacts bracket preventing positive
latching.
• Passive Access latch pin (bolt assembly) for
positive securement, wear, misalignment, or
other damage
• Missing or damaged ramp retaining hairpin
cotter and/or floor rotation flat washer
• Top and/or bottom ramp pivot points (axles
and/or bearing surfaces) for deformation,
wear or other damage
(apply * Light Oil)
Remove ramp motor cover and inspect:
• Motor mounting bolts for securement (loose
or missing)
• Ramp fold arm securement (key)
• Microswitches securement and adjustment
• Microswitch wires and terminals for secure-
ment or damage
Inspect ramp, ramp fold arm and hinge assem-
blies for broken welds, stress fractures, etc.
Inspect Kneel actuator assembly for:
• Actuator mounting bolts securement (loose
or missing)
• Actuator shaft/chain bearing slots for
excessive wear or damage
• Actuator shaft/chain bearing slots for
lubrication
(* Light Grease)
(continued)
1 Year
or
1250
Cycles
continued
continued
Maintenance
Summary of Contents for EntervanII
Page 45: ...Page 43 Notes Troubleshooting...
