Braun Pulse oximeter 1, Manual

Page: 6 / 84

8 9
SpO2 or PR reading is
unsteady
Finger is not fully
inserted into device
User is moving or
finger is shaking
Retry by correctly
inserting the finger
Remain as still as
possible
The oximeter can not
be turned on
Inadequate power or
power off
Batteries are
installed incorrectly
The oximeter might
be damaged
Replace the batteries
Please reinstall the
batteries
Please contact the
customer service
center
Unit turned off The product
automatically shuts
off when no signal
can be detected
within 8 seconds
Inadequate power
Normal
Replace the batteries
Low battery
displayed
Batteries need to be
replaced
Replace the batteries
Product specifications
Type: Braun Pulse oximeter, YK-81EUC
Display Type: OLED display
SpO2 Measurement range: 70% - 100%
Accuracy: 80% - 100% ±2%
70% - 79% ±3%
Resolution: ±1%
Pulse Rate
Measurement range: 30BPM~254 BPM
Accuracy: ≤ 100 ±1 BPM
> 100 ±2 BPM
Resolution: ±1 BPM
Power Supply: two AAA 1.5V alkaline batteries
Power Consumption: below 30mAh
Automatically Power-off: The product automatically shuts off
when no signal can be detected
within 8 seconds
Dimension: Approx. 58mm×35mm×30mm
Operation Temperature: 5 ºC~40 ºC (41 ºF ~ 104 ºF)
Storage Temperature: -10 ºC~40 ºC (14 ºF ~ 104 ºF)
Operation Humidity: 15%~80%
Storage Humidity: 10%~95%
Air Pressure: 70kPa~106kPa
This device conforms to the following standards:
IEC 60601-1: Medical electrical equipment – Part 1: General
requirements for basic safety, and essential performance.
IEC 60601-1-2: Medical electrical equipment - Part 1-2: General
requirements for basic safety and essential performance - Collateral
standard: Electromagnetic disturbances - Requirements and tests.
Limited 2 year warranty
A. This 2 year limited warranty applies to repair or replacement
of product found to be defective in material or workmanship.
This warranty does not apply to damage resulting from
commercial, abusive, unreasonable use or supplemental
damage. Defects that are the result of normal wear and tear will
not be considered manufacturing defects under this warranty.
KAZ IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL
DAMAGES OF ANY NATURE, ANY IMPLIED WARRANTY OF
MERCHANT ABILITY OR FITNESS FOR A PARTICULAR
PURPOSE ON THIS PRODUCT IS LIMITED IN DURATION TO
THE DURATION OF THIS WARRANTY. Some jurisdictions do
not allow the exclusion or limitation of incidental or
consequential damages or limitations on how long an implied
warranty lasts, so the above limitations or exclusions may not
apply to you. This warranty gives you specific legal rights and
you may also have other rights which vary from jurisdiction to
jurisdiction. This warranty applies only to the original purchaser
of this product from the original date of purchase. B. At its
option, Kaz will repair or replace this product if it is found to be
defective in material or workmanship. C. This warranty does not
cover damage resulting from any unauthorized attempts to
repair or from any use not in accordance with the instruction
manual. Refer to page 158 for list of European Contact
numbers. Please be sure to specify a model number.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT
CONSUMER RELATIONS FIRST OR SEE YOUR WARRANTY. DO
NOT RETURN THE PRODUCT TO THE ORIGINAL PLACE OF
PURCHASE. DO NOT ATTEMPT TO OPEN THE DEVICE
HOUSING YOURSELF, DOING SO MAY VOID YOUR
WARRANTY AND CAUSE DAMAGE TO THE PRODUCT OR
PERSONAL INJURY.
Errors and troubleshooting
Error message Situation Solution
SpO2 or PR can not
be shown normally
Finger is not fully
inserted into device
User’s
oxyhemoglobin
value is too low to be
measured
Retry by correctly
inserting the finger
Try a few more times
If you can make sure
that there is no
problem in the
product, please go to
the hospital in a
timely manner for
exact diagnosis
English