34
MANUAL P/N 900000111 REV K
Figure 16 Manual Setting of Time in NFS-220
4.5.2
10 MHz Output Level Settings
The Amplitude of each of the four 10MHZ outputs may be individually set by entering a nominal
amplitude value on the reference screen.
Each individual 10 MHz (J1 through J4) level may be set over a range of 1 to 255. These numbers
correspond to voltage levels shown in Figure 17 .
Note that the settings are accurate to ±10%, so the user should make fine adjustments by
measuring the actual output level with an oscilloscope or spectrum analyzer and make the
necessary adjustments by entering the number that provides the exact output level required.
Note that all values measured in Figure 17 assume the signal is terminated with a 50 ohm load.
