Brammo Enertia 2010, Owner'S Manual, Page: 57 / 92

Suspension
Your front and rear suspension systems use springs and hydraulic damping devices that suspend your weight and most of the weight of your Enertia.
Servicing Your Enertia 57
Front Forks
There are no user adjustments on the front forks.
Rear Shock
You can adjust spring preload, compression damping, and rebound characteristics of the rear shock.
(A) Spring Preload Ring
Turn the preload ring counterclockwise to decrease the preload, clockwise to increase the preload.
To adjust to standard position:
1. Raise the rear wheel off the ground using a safety stand or a hoist.
2. Loosen the 3mm set screw.
3. Turn the preload ring counterclockwise until spring is loose.
4. Turn the preload ring clockwise 4 turns.
5. Tighten the 3mm set screw to lock the preload ring.
(B) Compression Damping Knob
Turn counterclockwise to reduce compression damping, clockwise to increase compression damping.
To adjust to standard position:
1. Turn clockwise until it will no longer turn (lightly seats).
2. Turn counterclockwise ½ turn.
(C) Rebound Damping Screw
Turn counterclockwise to reduce Rebound Damping, clockwise to increase Rebound Damping.
To adjust to standard position:
1. Turn clockwise until it will no longer turn (lightly seats).
2. Turn counterclockwise 10 “clicks”.
A
B
C
Preload Spring and Compression Damping Knob
Rebound Damping Screw
   
NOTE
The rear shock is charged at the factory with a small amount of nitrogen. If
you attempt to check the pressure, all of the nitrogen will escape resulting in
the shock not operating properly.