PC IEEE Reference
Installation Guide.
Figure 2-7. The IRQ Jumper Block.
_______________________________
NORMAL USE OF INTERRUPT.
________________________
ÚÄÄÄÄÄÄ¿
³
:::::
Þ³
FACTORY SET POSITION. NO IRQ.
ÀÄÄÄÄÄÄÙ
ÚÄÄÄÄÄÄ¿
³
::::
Þ
:
³
IRQ2 E.G.A. GRAPHICS CARD.
ÀÄÄÄÄÄÄÙ
ÚÄÄÄÄÄÄ¿
³
:::
Þ
::
³
IRQ7 PARALLEL PRINTER PORT.
ÀÄÄÄÄÄÄÙ
ÚÄÄÄÄÄÄ¿
³
::
Þ
:::
³
IRQ5 HARD DISK.
ÀÄÄÄÄÄÄÙ
ÚÄÄÄÄÄÄ¿
³
:
Þ
::::
³
IRQ4 RS232C SERIAL PORT NUMBER 1.
ÀÄÄÄÄÄÄÙ
ÚÄÄÄÄÄÄ¿
³Þ
:::::
³
IRQ3 RS232C SERIAL PORT NUMBER 2-8.
ÀÄÄÄÄÄÄÙ
Select the IRQ line required by placing the jumper across
the appropriate pins.
If in doubt leave in the jumper in the factory set condition.
Using More Than One PC IEEE Board.
__________________________________
Since each PC IEEE card can control up to 14 separate
IEEE devices it is not generally necessary to have more than one
PC IEEE board installed in the PC at any one time. However, it
is possible to control multiple IEEE buses from one Personal
Computer by installing several PC IEEE cards each controlling
its own IEEE bus.
The golden rules to follow to allow this are:-
i.)
Ensure that each PC IEEE card is set to a different i/o
Page 18
Chapter 2
