Installation Guide.
PC IEEE Reference
Figure 2-10. Removing Blanking Cover.
__________________________________
STEP 4 Choose an empty
expansion slot. The PC IEEE
488 interface board will fit
either a full length or a short
slot, a 8 bit PC type slot or a
16 bit AT type slot. In general
it is wise to leave the larger
slots free for those boards that
insist on greater room.
Remove the blanking cover
protecting the slot on the PC
back panel. KEEP the blanking
cover screw safely for later.
Figure 2-11. Inserting The PC IEEE Card.
_____________________________________
STEP 5 Now insert the PC
IEEE 488 card in the slot. Be
careful to ensure that the gold
plated pcb fingers fits neatly
into the i/o expansion
connector. Press down firmly
but evenly on the top of the
PC IEEE card.
STEP 6 The 24 way standard
IEEE 488 connector should fit
neatly through the slot’s
aperture to the outside world.
Use the screw kept back from the blanking cover to screw the
PC IEEE 488 interface retaining bracket into the PC back panel
housing.
Chapter 2
Page 21
