Brahler DIGIMIC, Operating Instructions Manual

Page: 32 / 46

Multi-Room operation
32
DIGI MIC®
wireless
Assignment of DMic/DDoc to a room (0 – 4)
Please make sure only one DSpark in your venue has activated the register function (register open –
LED OFF).
Please make sure that the preset of the different Radio Transceiver units DSpark is like described above.
Open Register (LED OFF) on your first DSpark (Local radio channel number 0). Make sure other DSpark
have their Register closed (LED on). Place the desired number of units on the table and press the MIC
button one after each other to register on the current DSpark.
Allocation of Docking Units DDoc
To configure the DDoc units press and hold the MIC button for at least 4 seconds. This procedure is
indicated by flashing of the multi MIC-LED. The previously stored room channel number will be reset. In this
mode DDoc searches for any Radio Transceiver units DSpark. If one is recognized DDoc tries to log in.
When successfully DDoc gets confirmation and stores the new radio channel number as default.
This will finish the configuration mode.
If there is no log-in possible DDoc will terminate the configuration mode after 30 seconds and then switch off.
When all microphones are working (successful login) a quick microphone test is recommended. Following
close the Register (LED ON). After this you can go to the second room and perform the same procedure with
a DSpark assigned to the next room (local room number 1).
Resetting of Docking Units DDoc
The DSpark Radio Transceiver Unit can reset all docking units DDoc which are allocated to this DSpark and
are in operating distance. Therefore press the inner buttons HIGH POWER and PRIO simultaneously for
about 5 seconds. The LEDs of HIGH POWER and PRIO are flashing for the time of deleting, but minimum
three times.
If you do this, all DDoc units will forget the room number they were tied to. This requires a new setup.