Brahler DIGIMIC, Operating Instructions Manual

Page: 25 / 46

Single operation mode
DIGI MIC®
wireless 25
Single operation mode
The following chapter describes the operation with one DSpark in autonomous mode.
System startup
Before starting a conference all units have to be registered by the Radio Transceiver unit DSpark. This is
easily done by just pressing the microphone key. Please ensure that the REGISTER LED is off. Successful
registration will lead the microphone ring and microphone button to flash twice.
DDoc Docking Unit
Before starting operation with the DIGIMIC wireless equipment make sure that the rechargeable batteries
inside the DDoc units are properly charged. Otherwise the battery pack has to be charged, either in the
DTray (Charging and transport tray for 10 DDoc) or with an external power supply.
The multicolor LED at the rear of the DDoc shows the successful login status, see table below.
Indication of battery status
There are three possibilities checking the status of the rechargeable batteries:
1) In operation
Æ
by a Multicolor-LED at the rear of the docking station.
The Multicolor LED has different indication modes:
White – for a few seconds ready for operation
BLUE – flashing no reception, battery ok
BLUE – not flashing radio reception ok, battery ok
(more than 1h operation time)
OFF – permanent Switches off automatically after 30
seconds for power saving
(standard operation mode)
RED – not flashing radio reception ok, battery low
RED – flashing no reception, battery low
(for less than 1h operation time)
Easy rule to remember:
Multicolor LED