Brahler DIGIMIC, Operating Instructions Manual

Page: 23 / 46

Slave mode
DIGI MIC®
wireless 23
Slave mode
Once connected to the central control unit DCen, the DSpark falls automatically into the Slave Mode. All
registered wireless DIGIMIC discussion units will be controlled now only by the Central Control unit DCen
and behave just like another line of wired discussion units.
For additional discussion functions, like Request-to-Speak-mode, name handling, robotic camera control,
software interfaces or combination with wired units the DSpark can be connected easily to the DIGIMIC
central control unit DCen. Only in this mode DDoc can be set into standby.
Sample application
Slave mode configuration together with wired units
Wireless Delegate Units DMic/DChair with DDoc
TMD/01
or
TM58/6
Wired Delegate Units DMic/DChair
D9 cable D9 cable
D9 cable
D9 cable
DSpark
Radio Transceiver Unit
DCen
Central Control Unit
D9 cable
TMD/01
or
TM58/6
Connections see product information
Connections see product information
Figure 10
The connection to the Central Control unit DCen is done by the D9 system cable used for the wired delegate
units DMic it provides power and data. The D9 system cable is a high flexible shielded CAT5 cable with
lockable S8G-connectors.
Note:
The Radio Transceiver Unit DSpark will switch over automatically into Slave Mode if it is connected
to a Central Control unit DCen. In this case no settings are possible at the DSpark. The DIGIMIC
discussion units will be controlled now by the Central Control unit only and also all settings will be
assigned here.
Microphone
Microphone