Brahler DIGIMIC, Operating Instructions Manual

Page: 15 / 46

Autonomous mode
DIGI MIC®
wireless 15
Settings at DSpark
All functions are activated when pressing the corresponding push-button. The corresponding control LED will
light up when a function is activated.
Figure 6
For basic configurations the DSpark can be used autonomously offering the most common functionalities for
discussion systems like AUT3 or PRIO.
Factory (default) settings
When you start the system for the first time the DSpark Radio Transceiver Unit comes up with the factory
settings, which enables you to use the microphone system right away with the most common settings without
any additional adjustments. Any changes of these parameters will be stored automatically and available
when you restart the system the next time. The factory settings can be recalled at any time if required.
To recall the factory settings please follow these steps:
1. Switch off the DSpark Radio Transceiver Unit
2. Push and hold the LS INTERN button
3. Switch on the DSpark and hold the LS INTERN button furthermore
The LEDs REGISTER, HIGH POWER, PRIO and LS INTERN will be light up one after another
4. If all LEDs are on, hold the LS INTERN button furthermore for minimum 5 seconds, then you can
release the button
5. Switch the DSpark off and on again
6. Now you have set the DSpark to the factory (default) settings
Control LED Push-button for activation
Transmitting antenna
Receiving
antennas