Brahler DIGIMIC, Operating Instructions Manual

Page: 17 / 46

Autonomous mode
DIGI MIC®
wireless 17
Otherwise (LED off) external signalsAudio signals are routed to the DMic loudspeakers, e.g. from a mixing
console like shown below.
Audio from DMic micro
Audio to DMic loudspeakers (LS)
Figure 8
REGISTER
The function "REGISTER" is for administration and registration facility of the microphone units. For radio
transmission only registered units are permitted.
The delegate unit REGISTER list can be opened (LED off) or closed (LED on).
Use REGISTER open (LED off) during setup.
During setup you switch on and register your units to the DSpark. The DSpark will automatically put all
recognized units into an internal list. This list will be expanded as long as the register function is open (LED
off).
To save this list close the Register (LED on). Once the register is closed no more units can be registered to
this particular DSpark. This function offers you the following opportunities:
1. The wireless system is now completely closed (like a wired one) and cannot be intercepted by any
other unregistered wireless DIGIMIC units.
2. This register function also enables to use multiple DIGIMIC wireless systems within one building by
simply assign your units to the DSpark of the corresponding room (please refer to page 27 for more
details)
Note: The list is stored automatically.
To delete the list press and hold button “register” for minimum 5 seconds. The corresponding LED
will flash two times to indicate that the list is deleted.
Note: You can exchange the battery pack of registered units even when the register is closed.
VOX Mode autonomous
With the VOX mode it is possible switching on the delegates units (DMic, DChair) just by voice. That means
the member begins speaking and simultaneously the microphone unit is switched on. Turning off is done
with delayed once speaking is finished. This way is indicated by turning off the LED of the microphone.