Express® Lavatory System SS-Series
SS-3/AZ/WH97TAS
Installation - Obsolete
10
4/24/08
Bradley Corporation • 215-1175 Rev. H; EN 08-805
Wiring Diagram
Installation Instructions continued . . .
Step 5: Completing installation
1. Turn on the water supply to the Express® and check for leaks.
2. Turn on the electrical power to the electrical outlet and pass your hand in front of each station’s
sensor until all the air is purged from the lines and water is flowing smoothly.
3. After testing is complete, reinstall panel to frame. Fasten panel with the ten Torx-head screws
provided (see Figure 3 on page 7).
4. START-UP NOTE: This unit is equipped with adaptive infrared control. It may take up to eight
minutes to properly adjust to the environment when power is turned on or if power is interrupted
for more than fifteen seconds.
Note: For Express® units with optional soap dispensers, see pages 12-13 for soap dispenser
maintenance instructions.
