21
Installation
Bradmar
™
Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Bradley
•
HDWP-INSTR-013 Rev. K; ECN 12-14-012
10/1/2014
11a Urinal Screens with Stirrup Brackets (Optional)
Before installing the urinal screen components,
determine the correct location for your application.
Draw a plumb line on all walls
representing urinal screen
centers (see chart below for
measurements). These marks
represent hole centerlines for
the brackets. Use a level to
transfer that mark to all other
plumb lines
.
A
Place the center of each stirrup bracket at each
established level line. Center the bracket opening
on the plumb line. Using the bracket as a template,
mark the hole locations on the wall . Remove the
bracket and drill a Ø
⁵⁄₁₆
" x min. 2" (51mm) deep
hole at each hole location .
B
Place the bottom of each urinal screen 18" (457mm)
up from floor. Establish a 1" (25mm) gap between
the finished wall and urinal screen edge. A spacer
may help to support the weight of the screen and
establish the appropriate distances.
D
Insert the plastic anchors in all
holes and secure the brackets with
the #14 x 2" screws provided .
C
Drill Ø ¼" holes through the screen at
each bracket hole
. Secure the screen
to the brackets with #10-24 x ¾" barrel
nuts and #10-24 x ¾" shoulder screws
provided .
E
Dim . "A"
Dim . "B"
Dim. "C"
estab
lished
level line
ur
inal
plumb
line
floor
Dim . "A"
Dim . "B"
Dim. "C"
15" (381mm) for 42" (1067mm) screens or
18" (457mm) for 48" (1219mm) screens
15" (381mm) for 42" (1067mm) screens or
18" (457mm) for 48" (1219mm) screens
24" (610mm) for 42" (1067mm) screens or
24" (610mm) for 48" (1219mm) screens
