8
Bradmar
™
Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Installation
10/1/2014
Bradley
•
HDWP-INSTR-013 Rev. K; ECN 12-14-012
6a Panels and Pilasters with Stirrup Brackets (Optional)
Pilasters located at walls should be mounted first. Start at one end and install a panel, then a pilaster.
Continue alternating until installation is complete. When installing in an alcove or in-corner alcove, use an "H"
bracket to secure the pilaster to the panel.
When installing pilasters at walls, the gaps range
from
½
" to 1
¼
" (13mm to 32mm). Refer to your
submittal drawing for your gap sizes.
Check to make sure the pilasters are plumb and level to each other. The pilaster height can be adjusted with
the leveling screw that was placed at the bottom of the pilaster (see page 5 for attaching leveling bolt).
Refer to your submittal drawing and leave the appropriate
gaps. Standard gap is 1" (25mm) between the panel and
wall and
½
" (13mm) between the panel and pilaster.
Using the brackets as a template, drill Ø ¼"
holes through the pilaster at each pilaster
bracket hole. Secure the pilaster to the bracket
with #10-24 x ¾" barrel nuts and #10-24 x ¾"
shoulder screws provided .
Using the hole in the shoe as a template, drill a
Ø ¼" hole through the pilaster and secure the
shoe to the pilaster with #10-24 x ¾" barrel nuts
and #10-24 x ¾" shoulder screws provided .
Using the hole in the shoe as a template, drill a Ø ¼"
hole through the pilaster and secure the shoe to the
pilaster with #10-24 x ¾" barrel nuts and #10-24 x ¾"
shoulder screws provided .
Set the pilaster into the shoe while at the
same time placing into the wall brackets.
A
Place a panel on the spacer and insert the panel into
the wall brackets.
Set the pilaster into the shoe while at the same time
placing the brackets around the panel.
A
B
Using the brackets as a template, drill Ø ¼" holes through
the panel at each panel bracket hole. Secure the panel to
the brackets with #10-24 x ¾" barrel nuts and #10-24 x ¾"
shoulder screws provided .
B
C
C
Spacer 14" (356mm)
Aluminum heatsink
on bottom of panel.
Pilasters at Wall
Pilasters with Panels
