12
Bradmar
™
Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Installation
10/1/2014
Bradley
•
HDWP-INSTR-013 Rev. K; ECN 12-14-012
8b Continuous Spring Loaded Piano Hinge (Optional)
Spacer 14" (356mm)
above finished floor
Use a 14" (356mm) spacer
to help support the weight of
the door .
(FOR ALUMINUM HINGE:
remove snap-on faceplate)
Place the door on the spacer
and set the gap at the hinge
and latch side . Standard gap
is
³⁄₁₆
" (5mm).
A
Center the hinge in the opening
opposite the latch and top to
bottom on door (approximately ½"
[13mm] down from the top of the
door)
B
Repeat procedures A-C for Stainless Steel Hinges
and procedures A-D for Aluminum Hinges .
E
Using the hinge as a template, drill a Ø ¼"
hole through the door at the top and bottom
hole . Secure the hinge to the door with the
#10-24 x ¾" shoulder screws and #10-24 x ¾"
barrel nuts provided.
Ensure that the gap on the latch side is
consistent and repeat procedure C on the
pilaster side .
Then drill a Ø ¼" holes through the remaining
hinge holes on the door and pilaster . Secure
with the fasteners provided .
C
ALUMINUM HINGE ONLY, FOR STAINLESS STEEL
SKIP THIS STEP:
Hold the snap-on faceplate squarely on
the leaf. Tap the faceplate firmly using a soft wood block to
protect the finish from hammer blows. Start at the top and
work downward until the entire length of the faceplate is
firmly engage . Secure the faceplate with a #8 x 1" flat head
Phillips drive screw .
To adjust spring tension, use a torx screwdriver and turn
the torx head clockwise approximately one complete
revolution. Insert a 1½" (38mm) long nail into the hole
through the hinge pin . The hinge pin has a hole in two
directions allowing adjustments to be made at every ¼ turn.
Check the swing of the door. If the door does not close fast
enough, remove the temporary nail and turn the torx head
¼ turn .
When desired tension is reached, hold the torx head in
place, remove the nail and insert the roll pin . Tap the roll
pin into place with a nail set until 1/8" (3mm) remains out
from the hinge .
D
Closed
Door View
Before installing the hinges, make sure the door openings are the appropriate size, all pilasters are
plumb, secured to the shoe and that the headrail is installed. Determine the door swing by facing the
compartment from the outside. Refer to your submittal drawings to determine each specific door swing
for your application.
Right-hand
inswing
(RHI)
Left-hand
inswing
(LHI)
Right-hand
outswing
(RHO)
Left-hand
outswing
(LHO)
Continuous Piano Hinge
Part # Prefix HDWP-S0209
Part # Prefix HDWP-S0208
The part numbers listed are prefixes only and
are used to identify the appropriate door kit
based on your door swing as determined above.
Inswinging doors should have hinges mounted
on the inside of the stall while outswinging doors
should have hinges mounted on the outside of
the stall .
(left hand in, right hand out,
knuckles facing front)
(right hand in, left hand out,
knuckles facing front)
Door
side
Pilaster
side
Pilaster
side
Door
side
