This unit has the ERD feature (Engine
Running Detection).
Then detecting electronic noises the BPB will be
in a standby mode, it will not disconnect the
power even when the battery energy is lower
than the disconnecting threshold.
IMPORTANT NOTE:
After the installation is
completed test the ERD function to make sure
your vehicle electronic noises are detected, if
not than you need to connect the :engine on”
wire to the ACC connector (see Engine On wire
instructions)
DIMENSIONS
Base 1 5/8” (4cm) x 2 1/4” (5.5cm), Height
(including removable protective cap)
2 1/2” (6cm), Brackets 1 1/4” (3.5cm) x 5/8”
(1.5cm) x 1/8” (3mm).
WEIGHT
Battery Prog Brain 220 gm, Accessories 210 gm,
Packaging 145 gm;
Total weight 575gm (1.3lb).
CURRENT SPECIFICATIONS
Operational Voltage:
9V to 28V
3 Milliamps
Operational Current Consumption for type I & IV
After disconnect:
100 Micro amps
Maximum Amperage:
1100 Amps, for 15
consecutive seconds.
Continuous Amperage Capacity:
250 Amps.
Disconnect Voltage Threshold Preset
11.8V
with
a time delay of
30 seconds
(This unit is
programmable and can be set differently by
using
STRSEnergy Programmer
)
Type IV RV Disconnect Voltage Threshold for:
10.5V
with a time delay of
30 seconds
(This
unit is programmable and can be set differently
by using
STRSEnergy Programmer
)
OPERATIONAL TEMPERATURE RANGE
-40°F (-40°C) to 257°F (125°C).
Battery
Prog
Brain is made of non-combustible and
none flammable materials.
Water proof:
IP 68
The Battery Prog brain is designed for 25,000 cycles.
GENERAL:
The Battery Prog Brain is installed on the
positive (+) battery post with the
post clamp provided. The clip end of the black
ground wire is fastened
to the negative (–) post clamp bolt or to the
grounded Chassis.
HELPFUL HINT:
The positive (+) side of the
Battery Prog Brain is the side printed.
TOOLS REQUIRED:
Tools required may vary
based on your vehicle. The most common tools
are; Open-end 5/16”, 9/16”, 10mm,
12mm,14mm, or adjustable wrench. Standard
and Phillips screwdrivers.
IMPORTANT NOTE:
Before beginning
installation, be sure your battery is holding the
proper charge. If your battery does not hold a
minimum charge (over 12V) it may be at the end
of its lifecycle. The Battery Prog Brain is designed to
protect a properly functioning battery. It cannot
restore or repair a damaged battery. If your
vehicles battery shows any signs of physical
damage such as swelling, leaking or cracking,
replace the battery prior to installing Battery Prog
Brain.
IMPORTANT NOTE:
Unless you are fully
familiar with your vehicles electrical system it is
recommended that installation of this product is
performed by a certified technician.
Summary of Contents for Battery Prog Brain
Page 5: ......
