Start the engine after installation is complete. If
the engine starts properly proceed to the next
step. If not, review the installation instruction or
consult a certified technician.
With the Manual Reset Control Knob in the
“ON” position turn the engine off and turn on as
many electrical accessories (i.e. lights, radio,
and wind shield wipers) as possible and leave
them on. The Battery Prog Brain will cut power from
the battery automatically – confirming the
Battery Prog Brain is working. This may take some
time, depending on the battery’s age and state
of charge.
The remote control unit supplied with Battery
supplied with the Battery Prog Brain IV can be used
to disconnect and reconnect power by choice
(as an anti-theft device), as well as reestablish-
ing power after draining. Press and hold for 4
consecutive seconds either the remote control
button or mounted switch to disconnect,
reconnect or reestablish power to electrical
accessories and to start the engine.
Start the engine, press the remote control/push
button and hold for 10 seconds
If the power was not disconnected the ERD
works OK, if the power has disconnected
The ERD do not detects the electronic noise
You need to connect the “engine on” wire.
Ensure that the Manual Reset Control Knob is
in the “ON” position and press it
down after the Battery Prog Brain has disconnected
the power (to reset). The unit should
reestablish power to the electrical accessories
and enable you to start the engine.
D) TO TEST THE REMOTE CONTROL UNIT /
WIRED REMOTE BUTTON UNIT(BATTERY
III & IV):
E) TO TEST THE ERD FUNCTION.
Prog Brain Type III and the wired remote button
Battery Prog Brain
BATTERY PROG BRAIN
PROG BRAIN
Summary of Contents for Battery Prog Brain
Page 5: ......
