•
Perforation Speed: Set the punching speed
o
Factor settings:
1.0mm
o
Optional settings:
0.1 - 9.9mm
o
Progressive perforation is effective
•
Touch Board Signal: Set the signal size when touching the board.
o
Factor settings:
1K
o
Optional settings:
1 - 499K
o
The value must be slightly larger than the actual touch panel signal; can not
easily be changed
•
Hit Board Delay:
Set the duration of the collision plate
o
Factor settings:
200ms
o
Optional settings:
10 - 500ms
o
The metal sheet touches the contact duration for more than the value.
•
Touch Up the Board:
In the waiting position, jogs when the touch board signal once
,
the Z-Axis immediately lift
s
a distance to avoid the workpiece and objects.
o
Factor settings:
No
o
Optional settings:
Yes / No
o
This parameter is invalid in the following state.
•
Alarm Lift:
In the following state when the touch panel has alarm FTC61 Z-Axis
corresponding to the operation made.
o
Factor settings:
Back to the original
o
Optional settings:
Back to the original / Waiting / Follow
o
Back to the original point.
Wait:
return to wait bit.
Follow:
Z Axes continue to
follow
•
Screw Pitch:
Set screw pitch (Z-Axis)
o
Factor settings:
10mm
o
Optional settings:
1 - 50mm
o
The setting must match Z actual screw pitch consistent.
•
Per Revolution:
Set the motor subdivision
o
Factor settings:
4000
o
Optional settings:
400 - 10000
o
The set value must be consistent with the Z-Axis motion control drive.
•
Calibration Multiplexing:
Set the input signal for the calibration / perforation
o
Factor settings:
Calibration
o
Optional settings:
Calibration / Perforation
o
Optional input CA. Calibration / Perforation signal.
•
Device Address:
Set the local address
o
Factor settings:
1
o
Optional settings:
1 - 99
•
Communication:
Set the communication rate
o
Factor settings:
9600
•
Restore Factory:
Enable the factory reset function
o
Factor settings:
No
o
Optional settings:
Yes / No
o
Select "Yes," the system parameters restore factory settings
•
Language Selection:
Set the display language
o
Factory settings:
Chinese
o
Optional settings:
Chinese / English
o
Support Chinese / English display
FTC61 SERIES MANUAL
Document Number: 855-910
Revision: 001 Revision Date: 6/1/2019
BOSSLASER - PAGE 5 of 12
