Rev 0 (1/17/08)
3
Disassembly
Disassembly
–
–
Fascia (Control) Panel (2)
Fascia (Control) Panel (2)
Control modules can be readily removed from fascia panels, but there’s a knack to it
– must use the procedure below exactly as shown.
HINT:
Don’t force modules out from fascia panels
to avoid breaking plastic parts. If modules don’t
come out easily, the procedure hasn’t been
followed and plastic parts will break.
Start from left side
Pry outer & inner tabs together L – R
Pry out (3) inner tabs + all outer tabs
HINT:
The knob does NOT have
to be removed to remove the
control module. The module lifts
off completely from the panel,
knob & buttons.
HINT:
Don’t remove the wire
holders – clip off wire ties
instead. Carry extra wire ties to
reattach wire harnesses.
NOTE:
Some control modules have been
replaced since fault codes stored in
module or motor control can’t be cleared.
Modules are operating properly and
shouldn’t be replaced to clear fault codes.
702_58300000133618_ara_en_a
