Rev 0 (1/17/08)
19
WFMC Service Tips
WFMC Service Tips
–
–
Test Program (2A): Fault Code Displays
Test Program (2A): Fault Code Displays
WFMC32/33/53
fault code displays flash –
alternating between fault code (
E:09
) and wash
when fault occurred (
C:01
)
Viewing fault codes
:
• WFMC32/33/53 displays alternate between fault code (e.g.
E:01
) & when fault occurred on in last 8 washes
(e.g.
C:00
) – shows
C:00
if fault didn’t occur.
• WFMC64/84 displays show fault code & when fault occurred on in last 8 washes (e.g.
0 - Er:01
).
WFMC64/84 Displays
WFMC64/84
displays show fault codes (
Er:09
) and
washes when faults occurred (
1
)
E:09
C:01
NOTE: Some control modules have been replaced since fault codes
stored in module or motor control can’t be cleared. Modules are
operating properly and shouldn’t be replaced to clear fault codes.
TIP: Washers are designed to give a service history, not show
only latest fault codes. Since fault codes stored in module or
motor control can’t be cleared, don’t expect fault codes to be
reset to “0” when repairs are made.
HINT: If “ERROR” shows on display and washer beeps while in
wash mode, check wire harness connections to control module and
from sensors (black wires), such as pressure sensor. Loose
connections may cause this code.
>START>MENU P1:ERRORS
1- Er:09
>START>MENU P1:ERRORS
1- dr:06
After control module fault codes have been shown,
displays show motor control fault codes (
dr:06
) and
washes when faults occurred (
1
).
WFMC32/33/53 Displays
702_58300000133618_ara_en_a