Rev 0 (1/17/08)
17
WFMC Service Tips
WFMC Service Tips
–
–
Test Program (1A): Starting
Test Program (1A): Starting
WFMC32/33/43/53 Test Program
WFMC32/33/43/53 Test Program
WFMC32/33/43/53
washer test programs self-diagnose problems, including listing the last
8
fault
codes from the control module & the last
16
fault codes from the motor control. The tests are
easy to use, speeding up and simplifying diagnosing washer issues.
NOTE:
Door locks
for all water fill and
drain tests.
HINT:
If
Start/Pause
light
doesn’t come on for
some tests, door is
open. Turn off
washer, then close
door.
Entering & using WFMC32/33/43/53 test programs:
•
To reset, rotate
cycle selector knob
to
Off
position.
• To enter test program, push and hold
Spin Selection
and
Delay Start
buttons at the same time,
then rotate
cycle selector knob ccw
to
Permanent Press Cold
position. Hold
Spin Selection
and
Delay Start
buttons until
P:01
shows in display.
• To select tests, push
Spin Selection
button (to scroll through tests) until desired test shows in
display
(P:01 - P:17)
-
Start/Pause
light will flash.
• To start tests, push
Start/Pause
button while its light is flashing -- light stays lit when test has
started. To end tests, push
Spin Selection
button.
•
To exit test program, rotate
cycle selector knob
to
Off
position.
P:01
WFMC53
702_58300000133618_ara_en_a
