AutoDome Modular Camera System
Adjusting Focal Length (Zoom) and Focus | en
5
Bosch Security Systems, Inc.
VG4-100 Series User’s Manual
F01U028033 | 1.0 | 2006.08
4
Adjusting Focal Length (Zoom) and Focus
To adjust the camera lens focal length and focus, perform the following steps:
1.
Select
Set Focus Now
from the
Install
menu.
2.
To adjust the focal length, loosen the focal (zoom) lock screw and rotate the lens mecha-
nism (WIDE or TELE.) until you achieve the desired field of view. See
Figure 4.1
below.
3.
To focus the image on the monitor, loosen the focus lock screw and turn the lens mecha-
nism (NEAR or FAR) until the image is in focus.
4.
Repeat both these adjustments until the desired view is in focus.
5.
Tighten both adjustment screws.
6.
Exit the
Install
menu.
7.
Remove the monitor jack and replace the covert liner and dome bubble when finished.
Fig. 4.1
Focus and Zoom Adjustment
5
Advanced Setup
The VG4-100 Series camera module normally provides an optimal picture without the need for
further adjustments. Advanced setup options, however, are available for obtaining the best
results from the camera under special circumstances. There are two upper level On-Screen
Display (OSD) menus: the
Main
menu and the
Install
menu.
The
Main
menu allows you to select and setup the picture enhancement functions. The
Install
menu allows you to set the camera ID, focus and synchronization settings. The
Main
and
Install
menus have settings that you can select directly or open to submenus for a more
detailed setup.
Focus & Zoom
Lock Screws
Focus and Zoom
Lock Screws
i
NOTICE!
Active menu selections can vary depending or the combination of camera, CPU and
COMM (communication) modules used. The menu selections described in this manual are
typical for a VG4-100 Series system.
