AutoDome Modular Camera System
Getting Started | en
3
Bosch Security Systems, Inc.
VG4-100 Series User’s Manual
F01U028033 | 1.0 | 2006.08
1
Getting Started
Install and wire the 100 Series AutoDome according to the
AutoDome Modular Camera System
Installation Manual
. A typical system includes a keyboard, matrix switcher, monitor, and appro-
priate wiring connections. Please refer to the individual product manuals for complete instal-
lation and setup instructions for each of the system components.
2
Camera Setup
To assist setup, the VG4-100 Series camera module can be connected to a monitor through
the miniature 2.5 mm monitor jack located on the camera circuit board. The monitor jack pro-
vides a composite video signal with synchronization. An optional cable (part number S1460,
SAP No. F01U500418) is available for making this connection.
To access the monitor jack, remove the bubble and covert liner:
1.
Insert a small screw driver through the keyway in the Pendant trim-ring, rotate the dome
bubble counterclockwise and remove the dome bubble. For In-Ceiling AutoDomes, you
must loosen the small screw in the trim ring before rotating the bubble.
2.
Press and hold the two retention buttons on each side of the camera module and then
pull off the covert liner. See
Figure 2.1
below.
Removing the covert liner provides access to the menu keys, and the pan and tilt thumbscrew
adjustment locks. See
Figure 3.1
on page 4.
Fig. 2.1
100 Series Camera Module
Covert Liner
Retention
Buttons (2)
Menu Keyboard
Monitor Jack
FRONT VIEW
BACK VIEW
Retention
Button (2)
Back View
Menu Keyboard
Monitor Jack
Front View
Covert Liner
