Hold Down Functions
Hold Down Functions have been incorporated to allow easy activation of specific operations. When a button is held
down for two seconds, two beeps will be heard and a particular function will operate. These functions are listed below.
Testing The Dialler
Telephone monitor mode allows the remote codepad to be used for a visual representation of data transmissions
between the control panel and the base station receiver. The dialling sequence is also shown in this mode.
The codepad will beep once every two seconds while telephone monitor mode is turned on regardless of whether the
system is in Installer's Programming Mode or normal operating mode. The first five indicators are used to display the
progressive steps for a transmission to the base station receiver.
Zone Indicator
Dialling Event
1
Telephone Line Seized
2
Dialling Phone Number
3
Handshake Received
4
Data Is Being Transmitted
5
Kiss-Off Received
None
Telephone Line Released
Telephone Monitor Mode Indications
How To Turn Telephone M onitor M ode On and Test The Dialler
1.
Enter your
followed by
7
and the
button.
Three beeps will be heard.
2.
Hold Down button
9
for two seconds until two beeps are heard to initiate a test report.
How To Turn Telephone M onitor M ode Off
1.
Enter your
followed by
7
and the
button.
Two beeps will be heard.
Each zone contains five locations. The first four locations determine how the zone operates, while the last location
contains the dialler reporting information.
Function
Description
AWAY
Arm The System in AWAY Mode
STAY
Arm The System in STAY Mode
0
Reserved
1
Horn Speaker Test
2
Bell Test
3
Strobe Test
4
Toggle Day Alarm On and Off
5
Fault Analysis
6
Initiate a Modem Call
7
Reset Latching Outputs
8
Codepad ID Beeper Tone Change
9
Initiate a Test Report
Hold Down Functions
Solution 6+6 Wireless On/Off
Quick Reference Guide
ISSUE 1.20
Page 8
Bosch Security Systems Pty Limited
