W ireless ON/OFF Interface
W iring Diagrams for Keyswitch Zones
Figure 1: Wiring Diagram for Keyswitch Zone
Figure 2: Wiring Diagram for Keyswitch Zone in Partitioning
Note 1:
When choosing an EOL resistor value other than the default 3K3 for a non-partitioned system, the
keyswitch zone must still use a 3K3 EOL resistor as shown in “Figure 1”. The keyswitch zone will not
operate with any other resistor value.
Note 2:
When using a keyswitch zone in partitioning, to enable arming/disarming of area 2, there is no need to
enable split EOL resistors when not using tamper zones. Simply wire the zone as shown in “Figure 2”.
Solution 6+6 Wireless On/Off
Quick Reference Guide
ISSUE 1.20
Page 16
Bosch Security Systems Pty Limited
