Installer’s Programming Commands
There are several commands that can be invoked to perform the functions as listed below. These commands only
operate while you are in the Installers Programming Mode. To invoke the command, press in the corresponding
numerical code then press the
button.
Command
Function
958
Enable and Disable Zone Status Mode
959
Test Programming Key
960
Exit Installer’s Programming Mode
961
Set Defaults For Contact ID Format (Factory Default Settings)
962
Copy The Panel Memory To The Programming Key
963
Copy The Programming Key Data To The Panel Memory
964
Wipe Programming Key
965
Set Defaults For Domestic Reporting
966
Enable and Disable Automatic Stepping of Locations During Programming
999
This Command Displays The
Solution
Panel’s “Software Version” Number When
Using An BOSCH Hand Held Programmer
Installers Programming Commands
Installer Code Functions
Installer Code Functions are designed to allow the installer to perform various system tests without the need to know a
Master Code.
The
is entered followed by a
digit then the
button to enter you into a particular
mode. If a button is not pressed within any sixty second period, the mode will automatically terminate.
+
+
These functions can only be carried out while the system is in a disarmed state.
Function
Description
0
Fault Analysis Mode
1
Reserved
2
Set Number Of Days Until The First Test Report
3
Event Memory Recall
4
Walk Test Mode
5
Satellite Siren (BOSCHSAT) Service Mode
6
Initiate Modem Call
7
Turning Telephone Monitor Mode On and Off
8
Reserved
9
Send A Test Report
Installer Code Functions
M aster Code Functions
Solution 6+6 Wireless On/Off
Quick Reference Guide
ISSUE 1.20
Page 6
Bosch Security Systems Pty Limited
