Quick Start
The following steps will enable you to use the
Solution 6+6 Wireless On/Off
control panel with the
default values as set in the factory. The default settings allow the panel to communicate in Contact ID format.
1.
Connect AC power to the unit.
The
MAINS
indicator will remain on as will the
AWAY
indicator. The unit is now in the armed state.
2.
The back-up battery should now be connected.
3.
Enter the default Master Code
2580
followed by the
button
.
The
AWAY
indicator will
extinguish. The panel is now in the disarmed state. Installer’s Programming Mode can now be accessed.
4.
Enter the factory default Installer Code
1234
followed by
the
button
.
The
STAY
and
AWAY
LED’s will now flash simultaneously.
5.
Enter the primary and secondary telephone numbers and the Subscriber ID Number.
6.
Set the time for the test reports if this option is required. Any other programming changes required can also be
made, otherwise the factory programming default settings will be used.
7.
Enter command
960
followed by the
button to exit Installer’s Programming Mode. The panel will
return to the unarmed state and is now ready for use.
8.
Using a Master Code set the date and time
.
•
Enter
+
6
+
.
•
Enter the day of the month, then the month, then the year, then the hour, then the minute using the format
(DD,
MM, YY, HH, MM).
•
Press the
button
when finished.
Zone Default Settings
The default zone settings are as listed in the table below.
Zone No.
Zone Type
1
Delay
2 & 3
Handover
4 & 5
Instant
6
24 Hour
Note: The example given in this Quick Reference Guide is a simplified description of how to configure the
panel. The system offers many other programmable features which are described in detail in the
Solution 6+6 Wireless On/Off
Installation Manual (MA670I).
Solution 6+6 Wireless On/Off
Quick Reference Guide
ISSUE 1.20
Electronics Design & Manufacturing Pty Limited
Page 5
