VG4 Modular Camera System
Alternative Control Protocols | en
37
Bosch Security Systems, Inc.
User’s Manual
F.01U.133.268 | 6.0 | 2010.03
4.2
Pelco Protocol Mode
The Pelco Mode features Auto Baud Detection that automatically detects and adjusts the
AutoDome protocol and baud rate to match that of the controller. The AutoDome responds to
Pelco-D or Pelco-P protocol commands.
4.2.1
Hardware Configuration
The AutoDome is configured from the factory for RS-485 operation in
Pelco Protocol Mode
.
1.
Connect the controller's TX terminals to the AutoDome's TxD terminals. See the
AutoDome Modular Camera System Installation Manual
for complete wiring instructions.
2.
Pan or tilt the keyboard joystick to confirm that control has been established to the
AutoDome (approximately five (5) seconds).
Figure 4.1
RS-232/RS-485 Selection Switch
4.2.2
Pelco Keyboard Commands
Pelco control commands are composed of a sequence of two (2) keyboard inputs with the
following convention: 1) a
Command Number
and 2) a
Function
key input.
The AutoDome uses the
PRESET
command key to save and recall presets (pre-positions) 1
through 99.
NOTICE!
The AutoDome supports only the RS-485 protocol while in Pelco mode. It does not
transmit responses back to the controller.
NOTICE!
If control is not established, ensure that the RS-232/RS-485 selector switch is
positioned to RS-485 (outward toward the LED lights). This switch is located on the bottom of
the AutoDome CPU board, under the camera head and next to the LED lights. See Figure 4.1.
1
CPU Module
2
Switch Location
3
LEDs
4
RS485
NOTICE!
To save a preset, enter the desired number and hold the
PRESET
key for
approximately two (2) seconds. To recall a preset, enter the desired preset number (or
command) and momentarily press and release the
PRESET
key.
Summary of Contents for series VG4-300
Page 1: ...VG4 Modular Camera System VG4 200 VG4 300 VG4 500i en User s Manual ...
Page 2: ......
Page 138: ......
