VSB 40.1
PC Box
7-9
DOK-SUPPL*-VSB*40.1***-PR02-EN-P
after completed startup, because the mouse initialization occurs during
the booting process.
Note:
The connected mouse must be PS/2-compatible. Normally,
the BIOS reserves IRQ 12 for the PS/2 mouse. If there are
address conflicts, e. g., if IRQ 12 has already been used by
another PC extension card, you should change the IRQ of this
extension card to another IRQ, that is still not-assigned.
Note:
If a VDP display is connected to a VSB 40, the mouse can
only be connected to this one. The mouse interface XMS at
the VSB 40.1 has to remain free.
G4 Display Interface X71
The G4 display interface is assigned to the 25-pin D-Sub female
connector X71. To this female connector you connect via a ready-made
cable available as accessory (see page 11-2) a display VDP 16 or
VDP 40.
Note:
When the VSB device is delivered, the settings allow to trigger
both a connected monitor and a connected VDP.
How to change this selection, if required, is described in
section "Selection of the Graphic Driver" on page 6-1.
X71
–
G4 display interface
Summary of Contents for Rexroth VSB 40.1
