●
Avoid installation locations exposed to direct sunlight, as additional heat
development can occur.
●
Install the operator panel in a manner ensuring easy access to the front
panel (top side).
●
Lay all connecting cables in loops and use strain reliefs for all cables.
●
Keep as much distance as possible to noise sources.
5.2.2
Mounting Cut-out
To mount the operator panel proceed as follows:
1.
Create a mounting cut-out with 8 holes, diameter: 4.5 mm...
2.
Insert the operator panel from the front into the cut-out. Then insert the
mounting bolts M4 into the drilled holes.
3.
Fasten the operator panel by screwing the nuts at the rear side of the
mounting bolts.
22/52
Bosch Rexroth AG | Electric Drives
and Controls
Rexroth IndraControl VDP 92.3 | Project Planning Manual
Dimensions
Mounting the operator panel
